Recommended application field: Range: 260-Amps: for cutting mild steel up to 25 mm thickness with maximum resource supplies, with a complete lack of flash and the use of oxygen as the plasma gas, 340-amp: the maximum current for cutting mild steel up to 32 mm thick high cutting speed and high quality, 400 Amps: cutting stainless steel and aluminum up to 50 mm thickness, 760 Amps: total current from the current source follower N-401 with nitrogen as plasma gas, stainless steel and aluminum to 130 / 150 mm thick.

Advantages over analogues: Water injection plasma cutting system prevails NT4001 advantages: superior cut quality, high performance, maximum flexibility.

The development stage readiness: Introduced in production

Description of the development:
()
Plasma using oxygen as the plasma gas - optimum choice for cutting low carbon steels. McGrath absent in a wide range of thickness of the cut metal. This yields a higher cutting speeds at lower arc currents. Oxygen, when it is used as plasma gas, and improves the weldability and virtually eliminates carbon steel for nitriding. The surface of the cut edge of the parts only even and smooth. NT4001 designed for 100% duty cycle at a power of 80 kilowatts at the outlet to allow maximum use of time. Patented LongLife technology significantly increases the life of consumable materials by microprocessor control the arc current and the gas flow rate, thereby reducing costs. Longer life of consumable parts reduces downtime for replacement of consumables torch and increases productive work time. With a current of 260 amps or 340 for an oxygen plasma cutting up to 760/1000 amps for the nitrogen plasma cutting machine, you can quickly select any current at all times, which expands the range of Slitting NT4001 without adjustment from 1 mm to 75/130 mm thick stainless steel or aluminum. You can cut metal above, or below water level. It can be cut with oxygen or nitrogen so as to have maximum flexibility and high quality receive any metal. RF Remote Console allows you to have the power supply to 91.5 meters from the cutter with minimal interference (noise) high frequency. Additional control torch height and initial height adjustment using sensors provide the ability to automatically install the cutter in position providing a quality cut. Elements of the system: NT4001 - power supply; RAS620 - vodoinzhektsionny cutter, gas console, console valve and actuator; remote RF console. Also included is optional: the initial height sensor and torch height control, remote voltage regulation, water cooler, additional slave power supply N-401 or N-601.

Possibility of transfer abroad:
Licence's sale
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua