Purpose of the development: The drive is intended to control the pipeline valves.

Recommended application field: Actuator (EA) developed for the nuclear power plants located in the service area outside the containment (EP of "P").

Technical characteristic: Specifications: - Power EP is from industrial AC 380V, 50Hz; - The number of revolutions of the output shaft from 1 to 1024; - Shaft torque EP minimum 50 Nm; maximum 250nm; - Protection Case-IP GOST 14254; - Resource - at least 6,000 hours (18,000 cycles); - Switching capacity limit switch units to 3A; - Output speed - 50ob/min.

The development stage readiness: Introduced in production

Description of the development:
()
EP may be used in other industries at an ambient temperature range from +45 ° C to -45 ° C indoor and sheltered outdoor seating. EP has the following functions: automatic shutdown VC limit switches (two switches on the "Discovery" ("O") and two switches on the "Close" ("Z")) when the valve to the end positions in a range of 1-1024 rpm, with an error not more than 15 ° output speed FL; author omaticheskoe off VC when the preset torque value on the output shaft of the CE in the "O" position "Z" with an accuracy of ± 5%, signaling to IP end positions of the valve gate and the fact Response clutch torque limit; indication on EP: The value of open (closed) valves, LED indication "O", "N", reaching the set point at an intermediate position of the shaft EP "Crash", remote setting of the limit (end) and torque switches separately to " O "and" L "for autonomous control settings (PN) via infrared (IR) channel that comes with the EP without opening the drive. Setting resolution of the torque sensor to trigger coupling limit torque - 10Nm., Automatic switching of the EP position in the remote manual control, except samoperemescheniya valve gate under the influence of the medium in the pipe, the creation of the output shaft torque in the range 50 ... 250nm up ± 5% of the maximum value given the number of cycles of operation EP, issuing a unified signal current of 5 mA, 0 mA or 4 mA to 20 mA, with a possible restructuring of the consumer from one range to another using the Mon in compliance with the requirements specified in ISO 26.011 (2; 6), lock the torque sensors with "failure" of the locking device in the range)% to 100% of valve travel, issuing diagnostic information (torque, time, speed, close - open - closed, smooth and uneven progress) archiving operator actions and operating parameters.

Information about newness of the development:
there are Ukrainian patents -- 1 items
there are patents of other countries -- 1 items

Possibility of transfer abroad:
Licence's sale
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua