Purpose of the development: Designed for operational control of the basic parameters of oil in the reservoir.

Recommended application field: Refineries, tank farms, oil storage facilities, gas stations.

Technical characteristic: Control oil level up to 1 mm; The range of oil level control - 0-20 m; Monitoring the density of oil with an accuracy of 0.001 g / cm3; Temperature control to within 0.5 ° C of petroleum products; Control of bottom water level up to 1 mm; Control of oil spills: - A double-walled tank by controlling the pressure of the inert gas in the interspace and / or by controlling the level of liquid in the interspace prostanstvo; - In double-walled tanks and single-precision control through changes in the level of oil in the tank in standby mode, and / or by comparing the cost of oil level gauge and fuel dispensers; Calculation of the free and occupied volume and weight of oil in each tank; Self-calibration system in operation; The degree of protection for explosion safety according to the standard Exia IIBT5; The block principle of the hardware and software, which provides: - Expansion of the system to 16 tanks (if applicable); - Ease of operation, repair and maintenance; No moving parts in the control area; Distance from primary transducer probe control tank to separate the overall system controller is not limited; Communication primary device sensors installed on each tank, with the overall system controller is carried out via RS-485; Provides control over unauthorized access to the tank with oil.

Advantages over analogues: Direct measurement of level, density of petroleum products and the level of produced water by controlling the buoyancy of the liquid in the tank with a precise reference to the geometry of the reservoir. Automatic self-calibration of the system by the use of reference points on the height of the tank. Continuous obtain information on the mass of oil in the reservoir.

The development stage readiness: Introduced in production

Description of the development:
()
The system is installed in the newly constructed and operated horizontal and vertical tanks. To install the control probe used 100-440 mm diameter hole in the lid of the tank. The simplicity of design of the probe control, the possibility of hardware and software make it possible to install and setup the system on a single tank for 3 hours (if you have completed the installation of piping and cable trays). Cost of the system from 1,000 to 5,000 USD (per tank) depending on the height of the tank, features and completeness of the system.

corresponds technical description
Conforms to technical characteristic

Possibility of transfer abroad:
Licence's sale
Technological document's sale
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua