Purpose of the development: CCS-320 and CCS-500 are used for manual welding with coated electrodes, as well as for semi-automatic welding electrode wire in shielding gas at a complete feeder, from sources such as GMR multioperator without ballast rheostats.

Technical characteristic: Parameter name CCS-320 CCS-500 Napr.pit., U input., V 45-90 45-90 Nom. welding. current, A (PV,%) 250 (100%) 320 (60%) 400 (100%) 500 (60%) Limits reg. welding. current, A 30-320 MMA MIG / MAG 100-320 30-500 MMA MIG / MAG 40-500 Limits reg. welding. eg., MMA MIG-MAG 21-32 14-32 21-40 MMA MIG-MAG 16-40 Weight, kg 13.5 25 Dimensions, mm MIG-MAG 16-40 580x285x375

Advantages over analogues: The main advantages of CRS-320 and CRS-500: the use of CCS-320 CCS-500 instead of the ballast rheostats reduce power consumption power source, allow you to remove the welding station at a distance of 200 meters from power sources, as well as to carry out electric welding work at a considerable height; KSU powered by open circuit voltage power source, as a result of stress that comes to KSU is electrical, and it helps prevent the welder from the high voltage when working at height, on the metal surface, the presence of digital display devices welding current (for CCU-320), the welding current and voltage (for LCP-500) infinitely adjustable welding circuit inductance (for CCU-500), continuously adjustable short-circuit current value in MMA mode, which allows welding electrodes with basic and cellulosic electrodes, can preset welding current MMA mode (for CCU-320) have a tough characteristic for GMAW and incident response for manual arc welding exclude mutual influence of welding stations for running on a single power source, can increase the number of positions for welding from one source mnogopostovoy through high efficiency; stabilize mounted welding mode when the power supply voltage of 45 to 90V, the presence of the regime "Hot Start" mode MMA (for CCS-320), as the welding power source, you can use the existing fleet of electric equipment, regardless of the year of issue, the functional complexity of and manufacturer, will improve the deposition rate by 5-8% while reducing the cost to remove spatter in the weld zone, the use of CCS can be a semi-automatic system for mnogopostovoy semiautomatic welding and simultaneous operation modes positions in MMA and MIG / MAG from the same source, have a built-in converter, which provides its own power control circuits and feed wire, have built-in automatic shut-off. In case of a welding more than 4 minutes. disconnects the output voltage back in occurs at the closure of the electrode to the work piece (for CCU-320), high degree of protection against the adverse effects of the environment, low weight and dimensions make it easy to KSU move them to field conditions, LCP-320 and KSU- 500 have all the properties of the inverter source, at the same time independent of changes in temperature and humidity as the inverter is safe (no power 380), as well as cheaper source inverter.

The development stage readiness: Introduced in production

Possibility of transfer abroad:
Licence's sale
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua