AKR-334 DEVICE FOR AUTOMATION OF THE CUTTING AND WELDING
Purpose of the development:
It is intended to move in all positions of the gas or plasma torch, hose holder or other semiautomatic burner for cutting, welding or welding, and can be used to move a test gauge in the control of the welding seam.
Recommended application field:
mechanical engineering
Technical characteristic:
the velocity of movement of the device infinitely adjustable within:
- For the AKP-334-01 - 0-20 m / h;
- For the AKP-334-02 - 0-40 m / h;
-tyagovoe force of at least 980 N (100 kgf);
-korrektirovka tool:
- Transverse joint - +/- 50 mm;
- Vertically - +/- 50 mm;
- Tilt tool - +/- 90 degrees;
-pitayuschaya network - AC voltage not exceeding 36 V;
-elektroprivod unit - motor with gear A5474.1.84.000;
-gabaritnye size - less than 190x270x300 mm.
The development stage readiness:
Introduced in production
Description of the development:
() Welding joints can be straight, curved or circular with a radius of curvature of not less than 150 mm.
Guide rail is made of steel strip section 68x6 mm or rolling unhandled corner section of 50x50 mm.
A method of fixing the rail:
- In installation conditions - permanent magnets, welding (temporary) stands, clamps;
- On the shop floor - on the racks.
corresponds technical description
Conforms to technical characteristic
Possibility of transfer abroad:
Licence's sale Technological document's sale Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|