PRECISION RAPID ANALYZER OF THE EXPERT 3L ALLOYS FOR ENGINEERING AND METALLURGY
Purpose of the development:
Analyzer EXPERT 3L provides a direct measurement of the mass fraction (concentration) of chemical elements in samples of metal alloys, non-destructive energy dispersive X-ray fluorescence analysis without standards.
Recommended application field:
Analyzers have been successfully operated on these businesses and organizations:
- Engineering and metallurgical;
- Recycling of scrap metal;
- Repair of equipment, engines and vehicles;
- Refining and jewelery;
- Mining and exploration;
- In the State Treasury of SBU;
- In the offices of the State Customs suzhby Ukraine;
- In the institutes of forensic Ministry of Justice;
- In the nuclear industry;
- In the food industry;
- In the institutions of the Ministry of Ecology and the 30-km Chernobyl zone;
- In the regional SES;
- In academic institutions.
Technical characteristic:
To equalize the sensitivity of light, medium and heavy elements of the analyzer is equipped with an automatic adaptive filters and automatically switch to the mode of X-ray tube.
The analyzer is set Si-PIN detector with a resolution of less than 155 eV for the line KaKn = 5.9 keV.
Equivalent dose X-rays on the surface of the instrument does not exceed 50 nSv / h
Radiation safety analyzer confirmed by the Ministry of Health of Ukraine.
Time to the device on the operating mode - 5 min.
Unit of measurement:
Dimensions - 412 h312 h312 mm;
weight - 12 kg.
Power supply: 100-240 V, 50/60 Hz, 60 VA.
Operating conditions: temperature 5-32 ° C, humidity not exceeding 80%.
Advantages over analogues:
The solution of most problems in elementary analysis.
Efficiency measurements.
Ease of use.
Low-cost analysis.
Reliable quality control.
EXPERT 3L-right shows the device: the measurement result - table of the elements found in the sample and mass concentrations.
The development stage readiness:
Introduced in production
Description of the development:
() EXPERT 3L - is:
- Installed in the manufacture of a single universal calibration of the instrument for all standard and custom alloys;
- The same high accuracy and sensitivity for all elements up to 2Mg 92U;
- Stability of metrological characteristics over the period of operation without adjustment and calibration transfer;
- Assessment of carbon in low alloy steels and cast irons;
- Analysis of samples of any composition and any form;
- Built-in printer.
Possibility of transfer abroad:
Licence's sale Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|