INSTALATIONPS TYPE OF FUM (FUM-P U1, U1-A FUM)
Purpose of the development:
Designed for filtration and purification from mechanical impurities and condensed moisture insulating liquids (including transformer oil), flooded in the oil-filled electrical equipment, as well as other liquids and gases, passive systems to structural materials.
Recommended application field:
Used as a stand-alone product and can be an integral part of systems and technological schemes for processing electrical insulating liquids.
Technical characteristic:
Parameter Value
Installing the ODM-P U1 Installation FUM-A U1
A capacity of not more than, m3 / h 20 -
2 Output, m3 / h - 3.6 - 6
3 The nominal fineness of filtration, m 5 5 + 0.5 + 0.5
4 weight content of mechanical impurities
in transformer oil at the outlet of the installation
one cycle of treatment, no more, / t May 5
5 Unified Resource filtropaketov up
regeneration, however, m3 1200 1200
6-Maximum allowable working pressure, MPa (kgf/cm2) 0.6 (6) 0.6 (6)
7 The maximum - allowable pressure drop across the
unified filtropakete, MPa (kgf/cm2) 0.25 (2.5) 0.25 (2.5)
8 Maximum power consumption. kW - 2.2
9 Power - three phase AC
V, B - 380 (10% -15%)
10 Overall dimensions, mm:
- Length of 905 ± 5 940 ± 5
- Width of 520 ± 5 670 ± 5
- Height of 960 ± ± 5 May 1220
11 Weight, kg 150 280
Advantages over analogues:
Analogues - are absent.
The development stage readiness:
Introduced in production
Description of the development:
() Installation is a coarse filter, pre-and fine-cleaning fluid, mounted on the frame. Set the type of FUM-A U1 is equipped Electropump units.
Operating environment (insulating liquid) is fed under pressure into the coarse filter that provides filtration fineness 200 microns. After passing through the coarse filter the liquid is separated into two streams, and is pre-(20 mm) and thin (5 mm) clearance. The two-stage filter system to handle at least 1200 m3 of fresh oil from the factory to the regeneration or replacement filtropaketov. The design allows the installation, if necessary, replace the contaminated filtropakety without disassembly of the technological scheme. Additional set filtropaketov supplied upon request.
Notes:
The initial state of the oil:
mass content of mechanical impurities, not more than - 100 g / t;
oil temperature is not lower than - 10 ° C.
Performance will vary depending on the type of electric pump unit to be installed on request.
They are manufactured according to TU U 29.2-04624312-028-2002 and have certificates of compliance systems UkrSEPRO Ukraine GOST State Standard of Russia.
Possibility of transfer abroad:
Licence's sale Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|