EXCHANGER GAS PIPE TG
Purpose of the development:
Heat recovery gas pipe designed to heat water heating systems through the use of clean and dusty heat of the flue gases of industrial furnaces.
Recommended application field:
Industrial kilns, thermal, glass furnaces.
Technical characteristic:
Heating Capacity, MW 0,3-1,18
Nominal water temperature, degree. C:
Inlet 70
Output 115
The nominal temperature of the gases, deg. C:
Inlet 450
Output 130-200
Aerodynamic resistance, Pa 450-600
Hydraulic resistance, 5 kPa
Gas flow, kg / s 1.0-3.5
Water flow rate, kg / s 1,6-6,5
Dimensions in mm:
body diameter 812-1476
height exchanger 1500-2000
total height of 3070-4670
Weight, kg 1320-5030
Advantages over analogues:
Preferred direction of flow: gases - from the top down, the water - from the bottom up. Implementation of TG provides:
- Saving of natural gas from 35 to 130 cbm / h;
- Increasing utilization of fuel by 10-20%.
The development stage readiness:
Ready for application
Description of the development:
() Heat exchanger is made of carbon steel. Consists of the input of the gas chamber, shell and tube heat exchanger, the output of the gas chamber. The design shell and tube heat exchanger tubes used with ring turbulators. Input gas chamber holds water cooled. Heat exchanger is equipped with air vent, a pipe for a safety valve, pressure gauge and manholes. Designed heat exchanger TG 6 sizes from 0.3 to 1.18 MW.
For dusty flue gas cleaning system is equipped with a TG, allowing clean the surface heating in automatic mode in the process heat exchanger.
The cleaning system is located above the front camera. Cleaning by compressed air at a pressure of 0.5 MPa.
Heat transfer coefficient of the heat exchanger due to the use of tubes with circular turbulence almost 2 times higher than in smooth tubes by decreasing the aerodynamic drag by 20-25%. TG metal is about 1.8 times lower than in similar devices.
Payback period for the installation of the unit - up to 1 year.
Used in the development of the invention according to the inventor's certificate of the USSR № 612 142.
Information about newness of the development:
there are inventor's certificate -- 1 items
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Licence's sale Licence's sale Technological document's sale Combinated reduction to industrial level Creation of joint enterprise
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|