Purpose of the development: Motor generators with auxiliary equipment designed to use as a primary or backup power supply AC 3-pin power in parallel operation with the industrial mains or battery work if you disable the industrial network, as well as combined electrical and thermal energy. Gas and gas-diesel engines can be used to drive the compressors, pumps and other units.

Recommended application field: --- In independent power plants; --- In the agricultural sector; --- In the housing sector: the boiler, pump stations and treatment plants; --- In the metallurgical and chemical industries (need uninterrupted power supply); --- Forestry (logging enterprises, woodworking plants); --- For the electrification of remote areas and heat; --- On the oil, gas, coal fields, terminals, etc.

Technical characteristic: Specifications: --- Nominal electrical power in kW from 315 to 800 --- Tension, 400/6300/10500 --- Current type AC 3-pin, 50 Hz --- Dimensions, mm length from 5070 to 5980 width from 1550 to 2070 height from 2925 to 3160 --- Weight, dry kg from 14,190 to 22,000 --- Resource to overhaul, 80,000 hour --- Full life, h 240 000

Advantages over analogues: OJSC "Pervomaiskdieselmash" during the period of operation provides all maintenance: - Execution of erection and start-up; - Training of personnel operating rules to the customer; - After-sales service; - Carry out the necessary repairs on site; - Modernization of the previously released diesels, their conversion to work on gas diesel and gas cycles; - Delivery of spare parts.

The development stage readiness: Ready for application

Technical and economic effect: Due to additional heat production is achieved: --- Increase the total capacity by 2.5 times; --- Increase efficiency up to 92%, which provides a 40% reduction in fuel consumption compared to separate production of heat and electricity. The low cost of electricity generated in the KSU allows a profit, pay off capital cost of its construction in the next 2-3 years. To organize KSU less land area that allows you to install them near the end consumer without breaking existing systems and high costs. Also available in frame KSU legkosbornom building.

Description of the development:
()
Cogeneration (CHP) are based on the engine-generators (ADHD) with recycling heat of the exhaust gases, engine cooling water, lubrication oil and gas-air mixture after the turbocharger. The fuel in the engine-generators are used: --- Natural gas; --- Petroleum gas; --- Mine methane gas; --- Bio-gas or other flammable gas with a lower calorific value 1200 kcal / nm [3] and the gas pressure in the supply line to the engine 0.05-0.4 MPa (0.5-4 kgf / cm [2]).

corresponds technical description
Ready for implementation

Possibility of transfer abroad:
Licence's sale
Licence's sale
Combinated reduction to industrial level
Creation of joint enterprise
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua