SEAL VALVE PRESSURE WITH PACKING RINGS TMG-F / B
Purpose of the development:
Sets Rings TMG-F / B are designed for sealing rods stop, adjusting
and special fittings with the parameters of the working environment:
--- Temperature - 196 ° C to +560 ° C;
--- Pressure up to 50 MPa (500 kgf/cm2).
Recommended application field:
Rings TMG puff type C is used as the heat in the water tap packing centrifugal pumps.
Rings TMG layered reinforced type CA with density 1.2-1.4 g/cm3 used as droseling and warm tap water in the packing of centrifugal pumps.
Rings TMG layered reinforced type CA with density 1.6-1.8 g/cm3 used as trailing in the packing, high-pressure valves (PN> 6.3 MPa).
Technical characteristic:
Tolerance rings TMG-F/V-1 unified, 2 of the stated (in size) can
provide final compression rings without damaging them. This tolerance is determined by:
--- Outer diameter:
for rings from 24 to 52 mm - not more than 2 mm;
rings for more than 52 mm - less than 1 mm;
--- The inner diameter:
for rings from 24 to 52 mm - less than 4 mm:
for rings from 52 to 80 mm - not more than 6 mm;
for rings from 80 to 104 mm - not more than 8 mm.
Advantages over analogues:
Provide final compression rings without damage tolerance allows
Unified TMG-F/V-1 rings, 2 of the stated (in size).
The development stage readiness:
Ready for application
Description of the development:
() The kit includes packing ring seals TMG-F/V- I1 and end ring TMG-F/V-I4
(obturate), the density of the graphite component - 1.6-1.8 g/cm3.
The optimal number of rings in a set (along with the end ring) depending on pressure:
-3 Ring at PN 6.3 MPa;
-4 Rings at 6.3 MPa PN 9 MPa;
-5 Rings at 9 MPa PN 14 MPa;
-6 Rings for PN 14 MPa;
Low pressure seal valves (PN <6.3 MPa) is carried out using packing rings TMG-F / B
density of 1.2-1.4 g/cm3; allowed stem seal oversize. In this case, the packing rings
TMG-F/V-1, 2 come with standardized dimensions, which are defined by the presence of the manufacturer
presform. Final compression ring is held in packing box.
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Licence's sale Technological document's sale Creation of joint enterprise Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|