PORTABLE FLOWMETERS WITHOUT INSERTS IN PIPELINES
Purpose of the development:
Portable measuring kit with ultrasonic flowmeter AKRON-01 is designed to measure the instantaneous
flow and integrated volume (quantity) of sound-conducting liquids in full pipes of water supply
and sanitation.
Recommended application field:
Utilities.
Technical characteristic:
Flowmeter Portaflow 220 B
Portaflow 220 brings a new level of simplicity to the non-destructive measurement of fluid flow. Consignment ultrasound device offers users a quick and accurate measurement of liquid flow outside the pipe.
The inner diameter of the measuring tube Portaflow 220 B - 50 ... 1000mm
Portaflow 330 flowmeter is designed for the rapid measurement of flow rate and the amount of fluid in the production lines, as well as in networks of hot and cold water. Built-in storage of information allows you to record daily, daily, etc. graphics fluid flow in the meter memory and transfer them to a PC for reporting.
Liquid Flow PT878-complete portable ultrasonic flowmeter system, fully equipped with accessories and enhancements, and allow to solve almost all problems by measuring the flow rate.
Advantages over analogues:
The main advantage of ultrasonic flow meters that are based on "Doppler effect", is the independence of the results of measurements of the pipe material, the composition of deposits and the flowing fluid. Enter only the internal
diameter pipeline. Is not measured by time of the signal from one sensor to another, and the change in frequency of the reflected
signal from moving in the stream of particles, bubbles, turbulence. It does not require very accurate setting of the sensors on the pipeline.
Dual channel with a laptop.
The development stage readiness:
Introduced in production
Description of the development:
() Portable measuring kit with ultrasonic flowmeter AKRON-01 includes a sensing device
PP-1 and the electronic unit BE-2 connected RF cable.
Portable kit with contact sensor Swan KR-01:
Temperature and pipeline wall thickness, flow velocity, flow rate and the amount of fluid in
pressure piping systems, heat and water supply and sewage systems, determination of the distribution of flows without cutting into the existing pipeline (DN 50 - 1600 mm).
The thermometer measures the temperature of the surface of the pipe. Thickness gauge measures the thickness of the pipe wall. Flowmeter sends ultrasonic signals and calculates the speed of passage of the flow in the pipe for the introduction of internal pipe diameter calculates flow rate and directly displays it on the screen.
Portable kit with contact sensor Swan KR-101:
Temperature measurement of the pipeline wall, flow velocity, flow rate and the amount of fluid in the heat and water pressure pipelines and sewage systems, the definition of flow distribution without the tie-in to an existing pipeline (DN20 - 1600 mm).
Is different from the CD-01 impossibility to measure the wall thickness of the pipe.
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Licence's sale Technological document's sale Creation of joint enterprise Realization of finished commodity
Photo
Country
Russia
For additional information turn to: E-mail: gal@uintei.kiev.ua
|