Purpose of the development: The machine is designed for testing of metals, alloys and hard engineering plastics with the registration of PC data.

Recommended application field: Metallurgy.

Technical characteristic: Specifications: - The frequency of rotation of the lower sample (75 ... 1500) rev / min. - Measuring ranges of rotation of the lower sample: A-(75 ... 750) rev / min, B - (150 ... 1500) rev / min. - Measuring range friction moment: I - (1 ... 10) Nm; II - (2 ... 20) Nm. - Measuring ranges load samples: I - (200 ... 2000) H; II - (500 ... 5000) N. - Permissible reduced error frequency meter shaft bottom sample ± 3%. - The number of bits of a counter of the number of revolutions of the shaft - 6. - Nominal unit price of the least significant digit of the total count of the number of turns - 100 rpm. - The maximum permissible torque of friction for the samples disk drive in the range of A and B samples and shaft sleeve and disc pad   And in the range of - 20 Nm; - For samples shaft sleeve and disc pad in the range of B - 10 Nm. - The limit of permissible values ??of the mean square deviation of the random component of the reduced error   friction torque meter in static load - 1%. - Permissible deviations of the mean square error of the reduced load meter mode   static load - 1%. - Coefficient of slip samples with identical diameters (0 ± 2) (10 ± 2) (15 ± 2) (20 ± 2)%. - Powered by a three-phase AC power supply: voltage - 380/220V, frequency - 50 Hz. - Power consumption - 4.5 kW.

Advantages over analogues: An automated system for the collection of analytical data provides the ability to conduct simultaneous recording of up to 10 parameters in numeric values ??and a graphical display of the conservation of the results in Microsoft Word and Microsoft Excel.

The development stage readiness: Ready for application

Description of the development:
()
The machine consists of the test setup, remote control and data acquisition systems for recording to a PC. The machine mainly consists in erasing pressed against each other a couple of samples with a given force. When testing a pair of disk - a disk rotating both the sample as a slip, and without it, and in the vapor drive - block and shaft - sleeve designs - block and sleeve still. During the test the speed is recorded, the friction torque, the force of pressing, the wear and the number of cycles of use. You can record the temperature and tested in various environments.

corresponds technical description
Ready for implementation

Possibility of transfer abroad:
Licence's sale
Technological document's sale

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua