TECHNOLOGY FOR SOLID LUBRICATING COATING
Purpose of the development:
Technology solid lubricating coating is designed to provide performance parts in nodes without dry friction plastic or liquid lubricant compositions.
Recommended application field:
Mechanical engineering. Transport.
Advantages over analogues:
A comparison with similar products:
TZP metalfluoraplastic
1. The coefficient of friction 0.12-0.15 0,03-0.05
2. Life (h) 25-30 0.5
3. Load a bully, H 5000 1600
The development stage readiness:
Tested experimental exploitation order
Technical and economic effect:
The proposed HRC were first used in aviation in the control units of AN -70 slats, as well as in robotics on the inner surface of the air cylinder maintenance operation (total time on the air cylinder 000 at 1000 cycles).
Description of the development:
() Description of the development:
A solid lubricating coating (HRC) is produced in a slurry consisting of a fluorinated polyamide (PA-24), an organic filler and an antifriction additives (antioxidants tribopolimersozdayuschie components). The coating thickness is 0.15 - 025 mm. The heat treatment for curing is carried out at 190 * C for 2 hours and at 80 * C in the presence of a catalyst.
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Licence's sale Licence's sale Technological document's sale
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|