Declared technologies base

TRANSFER OF INNOVATIONAL TECHNOLOGIES

HIGH-POWER PULSED MICROWAVE BRIDGE


Purpose of the development: The device is intended for metrology and certification materials sensory systems pulsed spin resonance methods.

Recommended application field: Instrumentation, materials science.

Technical characteristic: Specifications of the unit: - The number of pulses in the series: 1 - 3; - Pulse duration: 10-100 ns; - The pulse power up to 20 W; - The frequency of recurrence of packs: 100 Hz and 1 kHz

Advantages over analogues: Advantage of the bridge, compared to peers is its low cost, ease of management , the optimal output power, the minimum pulse width . Low cost of the bridge is provided by the use of pulsed avalanche diodes span ( ATD ) , designed to enhance the microwave pulses , instead of expensive amplifiers traveling wave tube ( TWT ) . Easy to operate is provided by selecting schemes for direct gain for the receiving unit bridge. Output power of 20 W and a minimum pulse width of 10 - 100 ns is achieved by using a two-stage pulse generator coherent .

The development stage readiness: Ready for application

Description of the development:
()
Computer- controlled spectrometer electron paramagnetic resonance (EPR) RE1308 Q- frequency range (8 mm) , equipped with a pulsed microwave bridge will allow for certification materials sensory systems pulsed spin resonance methods . Pulsed microwave bridge configuration with a working frequency of 35 GHz (Q- band frequencies) : - Shifter , PIN modulator 2 cascade pulse amplifier , amplitude detectors , attenuator , circulator resonator , the protective device , balanced mixers . Device with an operating frequency of 35 GHz allows measurements : - Spectra echo detected electron paramagnetic resonance ( EPR ED ); - Relaxation time ; - Spectra of the modulation signal decay electron spin echo (ESE )

corresponds technical description
Ready for implementation

Possibility of transfer abroad:
Licence's sale
Technological document's sale
Creation of joint enterprise

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua

or fill out the form:
Organization name :
Address :
Settlement account :
Bank :
MFO :
OKPO code :

Scientific organization tutor's data :
Surname :
Name :
Patronymic :
Scientific degree :
Phone :
Fax :
E-mail :
Cooperation proposals (joint patent, joint enterprise, assembly sale and so on :
country: