INTEGRATED SYSTEM OF CONTROL AND MONITORING OF COMPLEX TECHNICAL OBJECTS - SENSYSTEM
Purpose of the development:
The systems are designed for granular control of technical parameters of equipment for power generating enterprises.
Recommended application field:
Multilevel control of technical parameters of the equipment in locations such as power generation operations and holdings. Objects of control and monitoring - all turbines and auxiliary equipment power generating plants.
Technical characteristic:
The main technical parameters :
Parameter Value Tolerance
Number of sensors of various types , not more than 128 pcs
Distance from the sensor to the control unit and alarm, no more than 400 m
The rate of exchange on the local network of the lower level , kbit / s 125 not more than
Power Consumption 50 W max
T * environment ( sensors ) , C *
- Vibro sensors from -40 to +150 range
- Other sensors from -40 to +120 range
MTBF , 10,000 hours at least
Redundancy measurement channels at least 2
Runtimes on tripping at least 20
mains , min
Advantages over analogues:
The system opens up new possibilities :
- Connecting to a single system all objects station and several stations holding allows us to control more
"transparent"
- Replacement of inefficient visual control on computer monitoring system allows for
optimization attendants
- Ability to make decisions about the timing of reliable preventive maintenance and repairs
- Optimization of the cost of the wait staff and equipment repair
- Improving the efficiency of operation of main and auxiliary assets
The development stage readiness:
Introduced in production
Description of the development:
() area Description
System The system is built on the principle of " open architecture " :
- Ability to connect new sensors of various types in Plug & Play mode
- Software control modes of sensors , systems and data without hardware changes
- Monitoring parameters in real time
Hardware - Pre- processing and digitizing analog performed in close proximity to the physical
sensors
- Embedded system testing and calibration of sensors
- Software control sensor modes
- Data transfer sensor measurements in digital form
- Continuous monitoring of performance measurement channels
Software - Ability to visualize , signaling and processing data on computers lower and upper levels
- Ability to perform additional processing due to the powerful computational tools
corresponds technical description
Guarantees stable results getting
Possibility of transfer abroad:
Licence's sale Technological document's sale Creation of joint enterprise Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|