STAFF CONTACT WELDING "CRAB"
Purpose of the development:
Apparatus "Crab" is designed for welding sheets, strips and rods of carbon and stainless steel titanium, etc.
Recommended application field:
Applying the device is easy to solve many technical problems arising in the course of repairs. Machine is indispensable for any enterprise and workshop (repair a car, motorcycle, manufacturing garden tools, eliminating breakdowns appliances, etc.).
Technical characteristic:
Technical data:
Supply voltage, V 380 (220)
Mains frequency 50
Maximum secondary current, kA 6.0
Power short , consumption
when welding is not more than , 9.5 KW
Time pass welding current
adjustable in the range from 0.1 ... 3.0
Compression force electrodes
adjustable in the range of 1.2 kN 0.2 ....
Range of plate thickness
Steel and titanium alloys , from 0.3 mm to 2.0 +0.3 +2.0
Diameter of welded steel rods , 6.0 to 6.0 mm
Performance Welding
steel sheets of thickness 1.0 +1.0
at most 90 welds per hour
Overall dimensions, mm
length 350
width 100
Height 235
Weight, kg 8 ( 0.5 )
The development stage readiness:
Introduced in production
Description of the development:
() The device is manufactured for use in temperate and cold climate ( UHL performance category 4 according to GOST 15150-69 ) .
Structurally, the device is designed as a portable welding gun with hand lever operation . The device provides full cycle of welding : pre-compression welding, forging . You can adjust the compression force of the electrodes , allowing to obtain the necessary pressure on the electrodes , regardless of the force applied to the handle . Electronic timer allows you to adjust the time zapuskaniya welding current from 0.1 to 3.0 depending on the thickness and material of the workpiece. Ability to change the removable holders and electrodes of different sizes and configurations allows the welded joints of complex structures in all positions . The unit can be attached permanently to the table M8 screw through the hole. Desired compression force electrodes selected by rotating the nut. The passage of the welding current is set to handle the existing scale. Sharpening electrodes is selected depending on the thickness of the workpiece. Before welding , check the selection mode parameters (pressure, welding time , electrode sharpening ) by test welding and testing of specimens gap .
Information about newness of the development:
ноу-хау--
1 шт.
corresponds technical description
Guarantees stable results getting
Possibility of transfer abroad:
Licence's sale Technological document's sale Creation of joint enterprise Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|