THERMISTOR PROTECTION RELAY FOR THREE PHASE MOTORS RT-23
Purpose of the development:
Relay RT-23 is designed for the control of three-phase motors and their shutdown in the event of an emergency.
Recommended application field:
The industrial sector of the economy.
Technical characteristic:
Supply voltage, V AC 150..260
Power consumption not more than 17
Turn-on time of the device, with not more than 5
The response time of the device when a fault is detected,
with not more than 10
Time to return the unit to working condition, with not more than 10
Nominal resistance temperature sensors output:
- 3 sensor ohms 1300
- 6 sensors, Ohm 2600
Weight, not more than 0.2 kg
Advantages over analogues:
The relay operates independently of the motor rated current and the type of start-up.
The development stage readiness:
Introduced in production
Description of the development:
() The device has the following features:
- Control of voltage in three phases;
- Monitoring the integrity of the insulation of the engine;
- Control the temperature of the motor windings on thermistors.
The device can be used in control systems and three-phase motors consists of two halves molded high-impact plastic housing. Inside the housing is placed carrier printed circuit board. On the back of the unit installed clamps for mounting on a DIN rail. On the front of the unit are indicators of voltage supply and alarm emergency. After the device is to monitor the inputs and outputs in the case of one of them a predetermined range - load disconnection. Load switching occurs only if the emergency lasts for 10 seconds. The unit returns to the operating state 10 seconds after failure of an accident.
Information about newness of the development:
ноу-хау--
1 шт.
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Technological document's sale Realization of finished commodity
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|