CONTACT HOT WATER UNITS FOR DECENTRALIZED HEATING AND WATER SUPPLY
Purpose of the development:
Independent heating of industrial, residential and office premises contact water heater.
Recommended application field:
Energy saving in heating.
Technical characteristic:
Space installation module is 1,7x4,0 1,3x1,5m2 m2, respectively, for capacities of 1.0 and 0.5 Gcal / h, the height of 4.2 m and 2.3 m. The weight of the basic units - 1800 kg 950 kg respectively for thermal power modules 1.0 and 0.5 Gcal / h.
Module 1.0 Gcal:
- Thermal power, Gcal (MW): 1 (1.16);
- The maximum rate. hot water, ° C: 95;
- The temperature of the combustion products after the exit from the installation, ° C: 50-55;
- The efficiency of the installation,%: 96-98;
- Type of fuel: natural gas;
- The number of burners, pcs: 1;
- Gas flow rate, Nm3 / h 120;
- The parameters of the fan Air pressure kPa - 2.5; costs Nm3 / h - 1360;
- The pressure of the gas upstream of the burner, kPa 20;
- The maximum number of products of combustion, Nm3 / hr 1500;
- Humidity of the combustion products: 100%;
- The amount of nitrogen oxides in flue gases mg / m3 120.
Module 0.5 Gcal:
- Thermal power, Gcal (MW): 0.5 (0.58);
- The maximum rate. hot water, ° C: 90;
- The temperature of the combustion products after the exit from the installation, ° C: 50-55;
- Efficiency of the plant,%: 96;
- Type of fuel: natural gas;
- The number of burners, pcs: 1;
- Gas flow rate, Nm3 / hr: 60;
- The parameters of the fan Air pressure kPa - 2.5; costs Nm3 / h - 650;
- The pressure of the gas upstream of the burner, kPa 20;
- The maximum number of products of combustion, Nm3 / h 750;
- Humidity of the combustion products: 100%;
- The amount of nitrogen oxides in flue gases mg / m3 120.
Advantages over analogues:
Developed modules provide hot water to 90-95 ° C, which is significantly higher than the central heating and the cost of 1 Gcal of heat in this case twice lower.
The development stage readiness:
Ready for application
Technical and economic effect:
One module of 1.0 Gcal / h of heat capable of an administrative or residential building area of 10 thousand m2, and a module of 0.5 Gcal / h - an area of 5 thousand m2. Cost of 1 Gcal of heat produced water-heating units is twice lower than in the central heating.
Description of the development:
() The technology and equipment for water heating in the contact water heating units heat output of 0.5 to 1.0 Gcal / h. The developed modules are combined pin and superficial methods of heating water, which provides its heating to 90-95 ° C, ie, higher than in the traditional hot water circuits. By using the latent heat of condensation of water vapor from the combustion efficiency (COP) module LHV fuel exceeds 96%. Flue gas temperature at the outlet of module 50-55 ° C. The module is equipped with mnogofakelnoy burner and combustion chamber disposed above the heat exchanger.
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Technological document's sale Combinated reduction to industrial level
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|