Purpose of the development: Laboratory Grain Mill "LZM" is intended for grinding of laboratory samples of grain crops and products with a view to the subsequent determination of quality indicators. The main purpose of the mill LZM - grinding samples for moisture determination.

Recommended application field: It is used in: - laboratories and grain-grain processing enterprises; - agriculture; - other organizations involved in assessing the quality of crops and their products. It is used in the determination of moisture content, oil content, as well as other factors, in determining which products require grinding without moisture loss.

Technical characteristic: Time grinding sample weight of 20 g - 45c The residue on the sieve №08 (at 20g sample weight) of not more than - 10% Mode - cyclical (5 minutes work 10 minutes break) The capacity of glass - 100cm. cube Weight milled product - no more than 50g Shaft rotation speed when idling, at least - 23000 rev / min Power consumption - no more than 230W Voltage, frequency, current, V / Hz / A - 220/50 / 1.0 Dimensions (diameter x height), mm - 140 x 205 Weight - no more than 1.2 kg

Advantages over analogues: 1. The shaft rotation speed when idling, no less than about 23000 / min, which enables high-quality grinding samples. Ret №0.8 sieve no more than 7%. 2. The grinding chamber is made of high-tech polystyrene plastic, that reduces friction and heating of the sample. 3. Material grinding chamber has a high heat transfer properties so that the sample is heated and dried. 4. The knife is made of tool steel, a unique heat treatment which does not make the knife fragile and unlike analogues knife breaks. 5. Laboratory Grain mill LZM is also used for crushing oilseeds.

The development stage readiness: Introduced in production

Description of the development:
()
Based on two-blade grinding product steel blade that rotates at high speed grinds grain. LZM consists of a commutator motor, mounted in a plastic housing, which is fixed at the top of the glass, closed by a threaded cap compound to form the grinding chamber, which is filled with the product to grind. Inside the glass, on the motor shaft is secured by a nut, steel two-blade knife. Turning Mills made a switch keyboard type connection to an electrical outlet using the cord, and plug. A sample of the grain to be ground is necessary to fall asleep in a glass mill, close the lid and turn the mill for 30-50 seconds. After the expiration of the specified time shut down the mill. For extraction of the ground product must open the cup lid and pour the contents into the receptacle, with a brush to clean the inner surface of the cover glass and product residues. Thereafter grinding mill ready for the next sample. Fineness of the product is governed by the duration of the mill work.

corresponds technical description
Conforms to technical characteristic

Possibility of transfer abroad:
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua