ANALYZER OF MATERIALS "INTROSCAN"
Purpose of the development:
Analyzer of materials Introscan is designed to measure stress magnitoshumovyh and structure of various metals.
Recommended application field:
Magnetic control of devices in the enterprise.
Technical characteristic:
Modes of operation of the device:
- with a magnetic field stabilization;
- with the stabilization of the magnetic flux.
Equipment:
set of converters, software and service
Measurement time (set):
0.1; 10
The presentation of the results:
the absolute values of the controlled parameter, in relative units
Dimensions of the device, no more than:
318x180x105 mm
Device weight (without converter):
5 kg
Power consumption:
from 50 Hz 220 V or 12 V battery
(Consumption less than 30 W)
Advantages over analogues:
1. Automatic creation and storage of an unlimited number of calibration curves.
2. Independence from changes in measurements over a wide range of the gap between the sensor and the poles of a controlled surface and the surface condition.
3. Presentation of information in relative and real terms.
4. Construction stress diagram in the sector 180 ° (when using a 4-pin probe).
5. Automatically determines the best control regimes.
6. Interactive mode of operation, user-friendly interface, a visual representation of the results of the scan in a linear or circular pattern.
7. Easy expansion device capabilities and adaptation to specific customer problems through the use of new user programs.
The development stage readiness:
Introduced in production
Description of the development:
() Computerized stress analyzer structure and ferromagnetic materials through the use of magnetic Barkhausen effect.
Introscan Analyzer allows:
- monitoring of residual and applied stresses;
- control of surface plastic deformation;
- determination of thickness of hardened layer;
- construction of diagrams of residual stresses in depth;
- evaluation of the stress in the surface layers;
- control of thickness, width and profile of the transition zone of the surface layers, hardened laser, plasma and other types of treatments;
- sdentification and control of burn marks;
- control the hardness of carbon and alloy steels;
- calibration under uniaxial and biaxial states of stress;
- control of biaxial stress state with four-parameter diagrams and special techniques.
corresponds technical description
Guarantees stable results getting
Possibility of transfer abroad:
Licence's sale
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|