Purpose of the development: Scissors are designed for straight transverse cutting of the sheet material is not more than 2.5 mm and a width of 2500 mm with a tensile strength - at 500 MPa (50 kgf / mm2).

Recommended application field: For businesses. Can be used in areas with temperate climates, heated and unheated rooms (- 20 ... + 40 ° C).

Technical characteristic: Parameters NKCH 3214 (2,5x2500) Maximum dimensions of the cut sheet with a tensile strength of 500 MPa: - thickness - 2,5, - width, mm - 2500. Maximum width of the strip, cut off at the stop, mm - 550. The frequency of the knife stroke, stroke / min - 28. Electric motor power, kW - 3. Dimensions: - length, mm - 3120, - width, mm - 2000, - height, mm - 1330, Weight, kg - 1800.

Advantages over analogues: The electric motor is switched on only during cutting, thus saving energy. Drive electromechanical with direct inclusion of the gear motor. Cutting is performed by adjustable rear abutment or markup. There is a local illumination cutting zone.

The development stage readiness: Introduced in production

Description of the development:
()
When cutting sheet metal with a tensile strength of over 500 MPa to determine the maximum thickness of the cut is necessary to use calculation schedule as per the operating instructions, and the hardness of the material to be cut is limited to 30 units on a scale Rockwell "C". Additional options: - setting the rear stop up to 1000 mm. - installing the front adjustable stop. - installing the front adjustable angle stop. - installation of supportive devices for cutting thin sheet at the back fence. Final tests every shear load and a certified quality management system.

corresponds technical description
Ready for implementation

Possibility of transfer abroad:
Realization of finished commodity

Photo

Country Ukraine

For additional information turn to:
E-mail: gal@uintei.kiev.ua