SELF-CLEANING FILTER WITH AUTO OPPOSES INKJET REGENERATION AND CENTRIFUGAL-GRAVITY CLEANERS
Purpose of the development:
Centrifugal gravitational cleaners (TSGO) are designed for cleaning low-viscosity fluids (mainly industrial water)
of suspended solid particles of impurities with a density greater than the density of the particulate carrier fluid (1800
kg / m3 or more).
Recommended application field:
Mining.
Technical characteristic:
Specifications self-cleaning filters:
The maximum fluid flow, m3 / hr 100
The maximum subtlety cleaning, 100 m
The permissible level of output
dirt, g / l 0.5
The viscosity of the liquid to be filtered, mm2 / s,
not more than 50
The minimum operating pressure of 0.3 MPa
Specifications centrifugal gravitational cleaners:
The maximum fluid flow, m3 / hr 2000
The maximum subtlety cleaning, 300 m
The permissible level of output
dirt, g / l is not limited
Maximum differential pressure, MPa 0,005
Advantages over analogues:
Developed fine filters, different contaminant capacity unlimited, unlimited
opportunity for performance, unlimited service life without maintenance work
replace or clean the filter, a low cost.
Developed simple filters for irrigation systems that ensure continuous operation of the system, regardless
the pollution of water supplied for irrigation.
The development stage readiness:
Ready for application
Technical and economic effect:
Produced in Poland under our license. In Polish mines safety regulations prohibited to operate irrigation systems without hydrodynamic filters DonSTU.
Description of the development:
() Filters are filters with the filter regeneration protivostruynoy. Cavities crude liquid filter and the filtrate separated by a partition (planar or cylindrical). A small portion of the surface of the filter element (up to 3%) is covered with a special wash
tracking device type. Upon reaching the pressure drop across the filter element design value, due to contamination of the filter screen is automatically included in the work of self-cleaning system. Automation system filter provided it off in an emergency, with the simultaneous opening
bypass line and turning a light or audible alarm.
The principle of action of gravitational and centrifugal cleaners is gravitational settling of solid particles in the
upstream liquid. Due to the initial swirl flow, which is achieved by a tangential feed slurry inlet through the inlet creates a field of velocities and pressures
SBI workspace, which provides for deposition of particulate contaminants into the hopper of a certain size at the bottom of the device.
corresponds technical description
Ready for implementation
Possibility of transfer abroad:
Licence's sale
Photo
Country
Ukraine
For additional information turn to: E-mail: gal@uintei.kiev.ua
|